Technical assessment
MCM reviews the product, defect type, required tests, cycle time, operator workflow and integration constraints.
Notre façon de travailler
From production problem to validated system.
MCM projects start with your product, your defect and your line constraints. The goal is to reduce risk before engineering, build a practical system and keep support close after commissioning.
Feasibility test
Real samples are used to validate detection, measurement, test sequence or traceability approach before the project is locked.
Engineering design
The team defines cameras, lighting, sensors, mechanics, electrical cabinets, fixtures, software and safety requirements.
Build and validation
The system is assembled and tested with your products to confirm pass/fail logic, repeatability and operator use.
On-site commissioning
MCM installs the workstation on the line, connects PLC/MES/traceability when needed and supports operator training.
Support and optimisation
After installation, the team stays close for adjustments, troubleshooting, software improvements and production follow-up.
Before quotation
What MCM needs to evaluate your project.
The better the initial information, the faster MCM can define the right technical route and avoid unnecessary complexity.
- Good and defective product samples whenever possible.
- Photos or videos of the production line and product handling.
- Line speed, product variation and expected reject method.
- Required tests, measurements, reports and traceability data.
- Available space, safety constraints and PLC/MES requirements.
Ready for the next step?
Send the product context and start with a technical review.
MCM will recommend whether the project should move to a feasibility test, pilot, quotation, meeting or technical demo.
English 
Portuguese 
French 
Spanish